How do I run a malware scan using Sentinel Anti-malware?

To run a Malware Scan

  1. Navigate to Sentinel Anti-malware -> Scan
  2. Select the specific domains you want to scan or choose All domains to scan all of them.
  3. Click the Scan button to start the scan.
  4. After the scans are complete the scan report will be listed under the Reports tab.

To View a Scan Report

  1. Navigate to Sentinel Anti-malware -> Reports
  2. Click on a Scan ID entry in the grid for the report you want to view.
  3. Any detected malware will be listed under the Malware Hits section.

To Perform an Action on the Malware hits

  1. Click on the Actions tab for the scan report.
  2. Choose an operation to perform from the select list (Quarantine, Restore, Clean, Email).
  3. Press the Run button to perform the selected action.

  • scan
  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

How can I view the contents of a file in the quarantine?

To View the File Contents Navigate to Sentinel Anti-malware -> Quarantine Click on a File...

How can I test that the Anti-malware detection is working?

Testing Sentinel Anti-malware Detection Download the eicar test malware into the httpdocs...

How can I change the interface language of the extension?

You can change the interface language under Settings -> Application Settings -> Locale...

Where are the configuration files for Sentinel located?

Centos/RHEL/CloudLinux/AlmaLinux Configuration files: // Linux malware detect (Anti-malware...

How can I enable third party anti-virus signatures within Sentinel to improve the ClamAV detection rate?

Sentinel supports enabling third party anti-virus signatures to improve the detection rate. Full...